ºù°íÇ»¿¤¹ÝÀÀ·Î Á¦ÀÛ¹ý

Step 1 : remove the purge valve ( the red button ) from the head of the water filtration unit.

Step 2 : put the 20x27 brass cap at the input and the 20x27 female-female adapter on the device at the output

as shown in the pictures above

Step 3 : drill a small hole into the 20x27 female cap and put a silicon tube with an adapter on the cap,

and then screw the cap on the output of the head of the device

Step 4 : Take the anti-scale cartridge and remove the bottom plastic grid and then all the crystals inside the cartdridge.

Below, all the components required for building the plasma reaction chamber.

Note : You must use two multiple thin wires cables ( 1.5 mm2 ) sheated with silicon due to the overheating of the wire

produced by the strong current flow.

You will find the required carbon rods in any rectangular 4.5 V Zinc-Carbon battery.

Step 5 : Mount all the components as shown in the photo above

Step 6 : Drill a 6 mm diameter hole at 25 mm from the bottom of the plastic cartridge,

then fix the plasma igniters with a 6x25 mm nut and a bolt as shown in the photo above

Step 7 : Place the reaction chamber into the transparent tank then fill the reactor with ordinary tap water

Step 8 : Put modelling clay to close the hole around the electrical wires.

Your BingoFuel Reactor is now ready for testing...